Apek Maxpad Manuel du propriétaire télécharger pdf (Page 31)

‘BLUE PRINTING’

YOUR ARROW RACING KART

(

cont

)

Affixing Side Pod Bars

Always tighten the rear bolt first as

the front hole is slotted.

Proper fitment & Alignment of Rear Axle Flanges & Axle

1. Firmly tighten both the far left & far right bearing flanges into their respective bearing hangers.

2. Slide axle through L/H flange, right up to the face of R/H bearing. Now wiggle axle front to back

& left too right, for proper alignment, it should move in each direction equally, relative to the

bearing. Now remove axle & repeat from the opposite side. You should now be able to slide the

axle freely between the two bearings.

3. Loosely put the third bearing into position and do the bolts up only finger tight. Now slightly

knock the top of the flange towards the left hand side of the kart.

4. Tighten the TOP two

bolts of the flange

first, followed by the

bottom bolt/s. Now

back each bolt off

slightly so as you can

spin them with the

spanner, but leave

them tight enough so

that they DO NOT MOVE left to right. Lightly tap the top of the bearing flange back towards the

right hand side of the kart. Whilst you are doing this you must continuously try to push the axle

through the flanges. Soon the axle will move freely, but if you hit the flange too hard it may bind

up again, in which case you will have to knock it back to the left again.

5. Now that the axle moves freely between all three flanges you can tighten the third bearing firmly.

6. Be sure when inserting axle that both ends protrude from the bearing by exactly the same amount.

‘BLUEPRINTING’ YOUR ARROW RACING KART 29

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 39 40

Pas de commentaire

Apek Maxpad Manuel du propriétaire Page 31